MC100 Universal Garage Door Mini Remote Control frequently asked questions (FAQ)
These are some frequently asked questions about the MC100 universal garage door mini remote control.
How do I program a second button on the universal remote control?
After pressing the learn button, go through the same programming method using the second button. This process will not over write the first button.
How do I erase previous codes and start fresh?
The codes cannot be erased, only overwritten. A newly programmed code will take the place of a previous code.
The remote control is not working, no LED.
The LED is also a power indicator, pressing a button on the remote should cause the LED to illuminate. If the LED does not illuminate after you press the button, replace with a 3V lithium battery, CR2032.
How can I stop one button from operating two doors?
If one remote control button is operating two doors, you must clear the memory of the garage door opener that you do not want the button to activate.
Where is my learn button located?
The learn button can either be found on the garage door opener or on an external receiver. To locate the receiver look for an antenna, some receivers will require a cover be removed to gain access to the learn button.
Visit the online manual for images of where to find your learn button.
What is the radio frequency of the remote control?
The remote control can transmit on 310MHz, 315MHz, 318MHz, 390MHz and 372.5MHz radio frequencies.
Is my garage door opener compatible?
Check the Compatibility Matrix
If I change the battery in the remote control, will I have to reprogram it?
No, the remote control should retain it's memory. If it does not, you will need to reprogram it.
Where is my learn button on my gate?
Most gate operators have a built in radio receiver or an external receiver. The receiver on a gate opener can usually be found within the cabinet of the operator. If it's a community gate, you may require permission to gain access.
Was this helpful?
