How To Erase Remote Control And Keypad Access

Erasing your programmed remote controls and keypads from your garage door opener's memory is useful for many reasons, including if you have lost your remote control or move into a new house. In addition to erasing the devices, this process also deletes all previous codes from the garage door opener's memory.

You can erase your remote controls and keypads by using the LEARN button on your garage door opener or by using the LEARN button on the myQ Control Panel. 

Erase Your Remote Controls and Keypads Using the LEARN Button on the Garage Door Opener

1. Locate the LEARN button on the garage door opener.
2. Press and hold the LEARN button on the door control until the LED turns off (approximately 6 seconds).
3. All previous codes are now erased. Reprogram each remote control and keypad you wish to use.
   • How to program a remote control
   • How To Program Or Change The PIN For Keypad Models 940EV And 877MAX
   • How to Add, Program or Change a Keyless Entry PIN

Erase Your Remote Controls and Keypads Using the LEARN Button on the MyQ Control Panel

1. Locate the LEARN button on the MyQ Control Panel.
2. Press and hold the LEARN button on the MyQ Control Panel until the LED turns off.
3. All previous codes are now erased. Reprogram each remote control and keypad you wish to use.
   • How to program a remote control
   • How To Program Or Change The PIN For Keypad Models 940EV And 877MAX
   • How to Add, Program or Change a Keyless Entry PIN