Programming a Security+ Remote to Use the Open, Close and Stop Feature
To program your 3-Button remote control to utilize the open, close, stop features follow the steps below:
-
With the door closed, press and hold the large remote push button.
-
Press and hold the Lock button on the door control.
-
Press and hold the door control push button.
-
After the opener lights flash, release all buttons.
-
Test the Remote Control
To test your 3-Button remote control:
-
With the garage door closed, press the large (Open) button on the remote, the garage door should open.
-
While the door is opening, press the large (Open) button again and nothing should happen.
-
Press the middle (Close) button while the door is opening or closing and nothing should happen.
-
After the door is open, press the middle (Close) button to close the door.
-
During the opening or closing of the garage door, press the third (Stop) button to stop the door.
Was this helpful?
