How to program the ARQ remote control to Light Controls

IMPORTANT: You may need another person to assist with programming.

1. Before you begin, locate the Learn button on the light control.

2. Make sure the light connected to the light control is ON.

3. (In vehicle): Press and hold the outer buttons on your ARQ™ remote control until the green LED stays solid (3-5 seconds).

4. Press and release the Learn button on the light control.

5. (In vehicle): Press and release the button twice that you would like to program.

6. Wait for the light to turn off, then immediately press and release any button on your remote control (within 3 seconds of the light turning off).

Test your ARQ™ remote control by pressing the button you programmed in step 4. If the light does not activate, repeat the programming steps.

You can also read our Frequently Asked Questions and watch programming videos on our website at